Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / engr mohamed abd el-raouf
medium voltage is 11 kv 6.6 kv 3.3 kv
high voltage 33 kv 66 kv and higher
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
Can I use star delta connected induction motor for dual supply voltage?
What is CVT and what is relation with wave trap?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
As per standard, transformer body earthing and other Equipment earthing (Equipment earthing) did not connect. but in LT side termination we are doing metal glanding in both side Transformer to PCC Panel through armoured cable, now X'mer body earthing and PCC Pane earthing (Equipment earthing) both are connect.is this safe for X'mer or other equipment?
state the working of discharge lamp?
Why are the laminations insulated from each other?
what is the safe meggar values for motor, transformer HT, LT and Cables? IF we want to replace I/C bay at our 220 kv substation which is of 140 mw load capacity bay to be replaced by 400 mw capacity bay.other than CT(1200/1) what are the other equipment i have to replace. why we generally use 3.5 core cable or in other word 1/2 core for neutral and also confirm me that in balance conditiob(3 phase)current in neutral will zero
How to megger test 11 kV cable and the acceptance IR value
how to select proper cable for ct wiring so that drop within the limit.
Is any generator is developed which is operated with out diesal or other expensive source?
what is the function of gss in the dg set.
during installation time of transformer and alternator which points we have to observed?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The slip when motor stalls is A 1 B 0 C 13.33% D 10.33%
why h parameter are called as hybrid parameter?
