Why a starter is used for a motor?
- 50 Answers
- 133726 Views
- L&T, Nilachal Polytechnic, I also Faced
- E-Mail Answers
Answer Posted / md.azizur rahman
Electrical starters are generally used to limit the sarting
current of the inputed voltage to any d.c. motor. when
voltage supply is given to a d.c.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
How many energy meters can be connected on a 15VA Voltage transformer. please send a calculation sheet.
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
PLEASE SEND ME NTPC RELATED INFORMATION LIKE WHICH TOPICS HAV MORE SCOPE,BOOKS TO READ,CUT OFF...PLEASE.mail at thiru.1203@gmail.com
Write down the name of 2 lady Bir Pratin of Bangladesh
what is 400kv doble circuit quadpole tower?
How to address the servo drive for motor
how many load we can take for lighting
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
how to calculate the change over time for star delta starter for different KW motor?
What is the use of bundle conductors?
What is the need for a controller?
How to calculate of maximum demand if given 628kw, 785kva, 0.8 p.f.
WANTCONTACT NUMBER & EMAIL/ WEBSITE TO CONTACT THE SECRETARY,MADHYA PRADESH LICENSING BOARD(ELECTRICAL),K- BLOCK,3RD FLOOR,SATPOODA BHAWAN,BHOPAL
