Answer Posted / himadri bag
rated output depends only current and voltage not in the power factor. so the transformer is rated in VA or kVA(V*I) not in kW(V*I*pf)
Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
How phase to phase voltage comes 440V.
what is ground fault in ACB?
completed BE & done apprentice at tneb & having experience 6 years. want to get c license. will apprentiship & BE be helpful for getting c license. will i get any preference by showing this?
upto how much low RPM we will run the commercial motor which is run through VFD without any problem occurs in motor.Motor rating Duty is S1 & RPM is 1400.
I have a CT meter with ratio 60/5. The meter reading of previous month was 3290.49 and that of current month was 3797.26. How many chargeable units as per normal meter should be my reading.
What is the Nyquist criterion regarding control systems?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
in ACB breaker requireding 3200Amps. buscoupler getting OFF mode and again it reset and getting normal position give me a required answer?
how to select diiferent power transformers of same capacity on no load loss and full load loss by economical point of view.?
what is the difference between general inverter and solor inverter clerly explain plz
What is the difference between electronic regulator and ordinary electrical rheostat regulator for fans?
in parallel operation of power transformer why the distance between power transformer and capacitor bank feeder is necessary to know
how to calculate the size of the HT cable
are there rmu for 3 transformer?
Terminal blocks is used for segregate the connections... There is any principle for terminal block..?