Interested to Buy Any Domain ? << Click Here >> for more details...
You have casted a column above your footing, and you found out
it is off its location by 5cm. What would you Do?
- 5 Answers
- 9496 Views
- Carillion, I also Faced
- E-Mail Answers
Answer Posted / rajesh.d.v.s.p.
i don't no in site but according to my knowledge if the column is with in the core there is no problem other wise any eccentricity u have change the design considered moment with respected to axial load
that was design the column with moment+axial load
P = P+ P.e
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
what might be the problem faced in the near future if the M-sand is used in the place of river sand during wall plastering? (As per IS)
01. a. Diagram of a slump cone…………… 1 b. Size of Slump Cone…………… 1 c. Volume of a slump cone by av. Dia method…………… 1 d. Volume of a slump cone by av. area method…………… 1 e. Volume of a slump cone by frustrum method …………… 1 f. Angles of slump cone …………… 1 g. Slump measured by slump cone due to…………… 1 h. Slump does not measured by cylinder / cube due to …………… 1 i) ii) i. Slump cone is to be filled in……………………..Layers.
What is the amount of work done by a carpenter, bar Bender and plaster Mason in interior and exterior plaster
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
why top layer of block work shoud be full size if any cut block adjustable than another layer?
How many cement sand ballast in cc 1:4:8 40mm
sir I got selected in rail vikas nigam limited and they call for interview but i don't what they will ask in interview please guide me if you have any experience
hi guys what happens if you are absent for a supplymentry exam?
The concrete slump recommended for beams and slabs; is?
what is that one cub metre plaster in cemant and fine sand
In an aggregate blending plant, water is sprayed before blending is performed. If the fine content in aggregate is as high as 25 %, will not the fines form into lumps / balls and distribution will not be uniform ? Further, the fines will stick onto the interior of pug mill and its content will be low. The mixed material is stockpiled for weeks / months before use. Will it not be better that blending is done in dry condition, and water will be added only during compaction at site. Please forward your comments and suggestions.
why we provide bent up reinforcement bars at l/4 ? if it is because of diagonal shear , how does it acts ?
There are two buildings one taller and one shorter whose time period will be grater and similarly the frequency ?
What is min thickness,min grade of conc & age of PQC ?
what is right & short method of measurement of slab&beam
