Interested to Buy Any Domain ? << Click Here >> for more details...
why we are using negative range like -750 to 0 mmwc in
closed tank?and what is the reason can you explain clear?
- 2 Answers
- 10490 Views
- Aarvi Encon, I also Faced
- E-Mail Answers
Answer Posted / navodit
whenever there is close tank, there is vapour which will
condensate in top taping tubing(LP taping), which will
remain there even after empty tank, that time output
pressure will be in negetive(as HP taping is empty and LP
taping has filled with condensate), as LP line is filled.
so negetive will shove 4 mA at negetive value
| Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
What is the difference bitween control net scaner and device net scaner
Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
how to calibrate mass flow meter (Coriolis)? Example calibration range: 0 to 2500 kg/hr line size 3" fluid: Etheline glycol (MEG)
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
who's take first position in process in the timing of new installation flow transmitter and control vavle. give the answer with logical trick.
control panel design guidelines
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
1- Explain about HPM 2- What is the FSC and explain the configuration of FSC 3- explain the complete loop of vibration, how it works (field to control room) 4- What is the use of proxymitter? 5- During job your partner effected with H2S then what you have to do. 6- what type of gland packing uses when valve glind is leaking.
Can any one tell me what type of question asked for instrumentation and control interview panel??? pls mail ramashankar.goel@gmail.com
Explain the combusion chamber
plz send me general of ongc
Calibration procedure for Electro magnetic Flow meter
what is wave length were using ?
how to calculate the total flow in square root
