What is a liquid resistance starter?where it is used??
Answer Posted / iam chaturvedi
Combination of water and caustic soda for improving the resistance in starter, that's called Liquid Resistance starter. If any slip ring Induction motor, at the time of starting given the external resistance required to rotor side, why because starting current and starting torque is very high. So we are using resistance starter depend on motor capacity , at that place using Liquid resistance starter. Liquid resistance starter (LRS) ,IN which external resistance is liquid media which is use for the starting method of slip ring motor. For starting of slip ring motor external resistance are required so that we use liquid (addition of some caustic soda)as resistance so that is called as LRS.
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
dg started in plc mode and load taken later one battery terminal connection will be disconnected by loose connection what will happen for dg and shall we connect battery terminals while dg in load time?
if 12v battery get discharged for 2 months after if we put charge it will charge again?how much time it will take to charge?
how we decide wire gauge for ac or dc coil and what is the basic diff. B/w these two coil?
what is the affect of earth's magnetic field on the frequency used in aircraft???
what are the interview question asked in wind mill about electrical
transformer spections :: input voltage 0-110-230v; output volage 0-10-12-14v; amp=3A using CRNO CORE, capcaity=50VA primary turns = ? ; secondry turns =?
Name the test signals used in control system
How to see the inductance in a transmission lines
Any one can explaination about calibration with rotating sub standards?
1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?
What does the letter CTNM in negative phase sequence relay means?
Transformer how to maintaince a check b check c check d check
what is thresold of perception
Why computer humming sound occurred in ht transmission line?
What is the de rating factor of cable? What is the importance of the de rating factor in cable selection?