Interested to Buy Any Domain ? << Click Here >> for more details...
1) How to calculate battery backup for ups as well as solar
with complete formula elaborately......
- 2 Answers
- 5287 Views
- I also Faced
- E-Mail Answers
Answer Posted / velmurugan, so/d, barcf, kalpa
Consider the 2 KVA online UPS.
specifications are as follows: output voltage: 230V, Pf:
0.8, Load is 1600W. DC bus voltage is 96V.
Now Total output is = 2000 VA
PF of the load is = 0.8
There fore output in watts = 2000x0.8= 1600W.
Efficiency of the inverter is 80% therefore power input to
the inverter will be = 1600/0.8= 2000W
DC current of the inverter section= Watts / Voltage
Consider the fully charged voltage = 13.5X8=108V
The DC bus voltage
up to which the battery can deliver= 10.5x8=84 Volts.
therefore maximum current drawn by the inverter when battery
is in line = 2000/84=23.8A
Now consider the backup required for the load, i.e 1 hour
back up is required to safe shutdown loads when power supply
is not available.
Consider a class 10 type of battery where it has a
efficiency of 90%, 300Ah battery.
the effective AH available for the load is 300x0.9=270AH.
For 1 hour duration the discharge current will be 27.0A
which is higher than the required value of 23.5A.
There fore for 2 KVA online UPS having the load of 1600W
with 0.8 pf load, it requires 300AH of 8 nos of battery for
1 hour backup.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
How to calculate VA rating for CT or PT or Control Transformer?
What are the material used for resistor?
How to calculate the efficiency of Turbo Generator(Alternator) in general....?
how can we determine size of a cable by knowing the kw or current rating of a load?how can we calculate the resistance box of a slip ring motor?
What is the Temperature to be set in Thermostat provided in Marshalling box of the Transformer / Motor.
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
Explain difference between stand by earth fault and residual earth fault protection?
May I know how much values to be set for earth fault, over current and short circuit values at 11kv side? I have 11kv van 1250amps rating. Present it's taking load 80amps?
What is transient Phenomenon?
What are the advantages of instrument transformer?
how can we change the phase angle b/w two phase?
Why dry type cast resin transformers tap link blast in HV side while power shut down times on load?
