Answer Posted / eid elatawy
Loop can be process loop or instrument loop
for instrument loop is the signal from/to Controller(DCS or PLC or....etc) and this signal started from the instrument(valve or transmitter or...)to junction box to DCS through multi core cable.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor
What is the minimum rating availalbe for weld neck orifice in market?
how do i tune dearator pr control valve using PID. we set the set point is 0.6kg/cm2 now i want 0.5 to 0.7kg/cm2 limits so what should i give p,i,d values. then pls explain how do set pid values for control valve tuning?
give some question relative instrument fitter?
key exchanges in wpa,wpa2,tls
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Why flow/pressure transmitter before control valve?
principle of automatic votage regulator
What is the diffrence between ff tx and non ff tx
what is the difference between attemperator and desuperheater ?
what is the protection system in solar turbine compressor
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
hi i am eswar i want to know the instrumentation interview questations for eil(engineers india ltd) i have applied for engineer post in eil please help in this.my mail id eswar310@gmail.com
Calibration procedure for Electro magnetic Flow meter
How we calculate orifice plat size???
