A synchronous machines has higher capacity for
(1) Leading power factor (2) Lagging power factor
(3) Does not depend upon the power factor of machine (4) None of
the above
- 2 Answers
- 15197 Views
- JSW, I also Faced
- E-Mail Answers
Answer Posted / abhishek srivastava
Leading power factor
| Is This Answer Correct ? | 63 Yes | 2 No |
Post New Answer View All Answers
why the check zone and main zone are used for Busbar Protn. scheem?
would you please give me any idea about the BARC interview question on electrical? i have an interview on 1st july.....plz hlp me.......its urgent......
what is the minimum winding resistance of 30hp compressor, to run or to switch on
Why it need to form a capcitor when it not been in use from three or two year. Plz describe it technically.
Block diagram of Power line communication?
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
Discuss about gear cutting machines.
What is dielectric loss?
How does PLC work for sychronising of Two or more DG sets?
During FEED, you will have all the information with regards to cable. How will you calculate the MTO for MV and LV Cables? what are your considerations?
state basic meaning of 'INDUSTIAL AUTOMATION'?
What is cable tray, its type, and its support?
how rectifier transformer work in electroststic precipetatore(esp?
how to prepare the technical test
Why Transformer Neutral having one earth pit ( more earth electrode resistance) whereas body have many earth pit ( less earth electrode resistance)?
