What is difference between Boring, Reaming and Lapping?
- 4 Answers
- 63131 Views
- Essar, HMT, I also Faced
- E-Mail Answers
Answer Posted / suranjan
I THINK REAMING AND BORING HAVE THE SAME PURPOSE..ENLARGING AND FINISHING THE EXISTING HOLE.BUT REAMING USES MULTI TEETH CUTTER WHEREAS BORING USES SINGLE TOOTH CUTTER.
LAPPING IS FOR FINISHING THE SURFACE BY RUBBING THE SURFACE..
| Is This Answer Correct ? | 12 Yes | 32 No |
Post New Answer View All Answers
hi please send the exam modle paper for mechanical engineering. Iam attending for vizag steel plant MT
Give the procedures in starting centrifugal pumps.
What is G U T protection?
What do you mean by cotter joint?
what is your expectation
Which theories of failure are used for ductile materials ?
what is the stanton curve?
What is the difference between basic hole and basic shaft ?
How do you repair a hydraulic jack?
any body hv a experience of L&T pget interview for mechanical thn send me question and experience to me as i hv interview on 8 th may so send me as soon as posssible on my mail id nilesh.spy2000@gmail.com
How to exite natural frequencies in a overhung rotor
what is an intensifier?
Any one please sent me a mahindra tractors model question papers.
State fourier’s law of conduction.
i want sample question paper for SECTION ENGINEER IN RRB.
