Interested to Buy Any Domain ? << Click Here >> for more details...
PID controller is used for which type of compensation……
a) lead comp. b) lag com. c) lead lag com.
- 12 Answers
- 23456 Views
- Engineers India Limited, I also Faced
- E-Mail Answers
Answer Posted / madhuri
PD Controller is used as High Pass Filter and Lag Controller
PI Controller is used as Low Pass Filter and Lead
Controller.
PID will act as Lead-Lag Controller
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is standard procedure of manual mapping in Radar type level transmitter?
i have done DAE in Instrumentation and Process Control. i have applied for an apprentice training in chemical company after three day my interview will be conduct but i need more information about industrial process control and controller. my e mail is imran_dilsetu@yahoo.com please tell me interview question relative to instrumentation ?
How to Calibrate Vortex Flow transmitter in field
what is zero and span ?
need to calculate flow rate with the help of dp range and orifice bore dia and size. range is 0 to 400 inwc and orifice size is 12 inch 150 # rf and bore dia is 7.180 inch. need to calculation for flow rate
what is the different between deflection type measurement and null type measurement in RTD?
what is the calibration procedure for magnetic flow meter @ onsite
Which type of diaphragm use in costic line, dm water line, natural gas line, oil line?
i want formula for flow control.am doing project in flow control using orifice . i know value of the flow level(Q) . upstream(p1) pressure, orifice diameter(Do) , pipe diameter(Di) and oil viscosity(Vi) how can i calculate downstream pressure
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch
how pressurize drum calibrated ?
How is flow measured in square root?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
