calculate multiplication factor of a trivector meter with
line ct ratio 200/5A, line PT ratio 11000/110V and meter CT
ratio 200/1A and meter pt Ratio 11000/110V.
Answer Posted / ajaz kirmani
Multiplication Factor MF = [ (200/1)x(11000/110)]
-------------------------------
[ (200/5)x(11000/110)]
MF = 5
Is This Answer Correct ? | 2 Yes | 5 No |
Post New Answer View All Answers
Define maximum demand?
Brief me about maintenance planning & sheduling of machine tool.
for a 500 KVA connected load, I calculated 30% of capactor for power correction. Even after using 225 KVR capactor PF is not improving. What could be reason for low Phase correction factor?
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
STATE USE OF ARC RUNNERS & SPLITTERS ?
What are the advantages and disadvantages of open loop control system?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
sir, i am 3 years diploma course pass out candidate.what type of certificate can i got in marine service.
How phase to phase voltage comes 440V.
what are the assumptions made in swineburne's test?
how to set relay setting? and example calculation...
Distinguish between nuclear power station with thermal power station for initial cost, starting period, cleanliness, and transportation of fuel
how the speed of the gets motor regulated. does it draw the same current on the all speed level.
PLEASE SEND THE PREVIOUS YEARS QUESTION PAPERS OF RRB JUNIOR ENGINEER-ELECTRICAL
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?