If one lamp connect between two phases it will glow or not?
Answer Posted / umar kamboh
Suppose a bulb operate at 415 volts. And there is three phase system (three phases have same voltage magnitude but 120 degree apart). The line-line voltage b/w any two phases is 415 volts (two phases have same magnitude but they will be 120 degree apart i.e 0,120 or -120).. ..The current b/w two point flow either when there is potential difference or there is phase difference (even when voltage magnitude is same).In our case (Bulb with two phases) second condition is full-filled.Hence the bulb will glow and then become dark and then glow (i.e it will blink).but remain glow for long time and will become dark for a small time (as compare to glow timing).
For further detail you may contact at
engr.umar29uet@gmail.com
Is This Answer Correct ? | 4 Yes | 2 No |
Post New Answer View All Answers
what is the constructional difference between a power transformer and potentian transformer?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
any one can explain what is the size of pvc,armoured, various sizes of powr cable dia?
If UG power cable both ends are to be earthed or what? If not why?
how the aircraft outer body and inner body is separated ?
What is voltage ratio of a transformer?
What is deference between MCB & MCCB & ISOLATOR
how brushed dc motor operating ?
explain the mode of metal iranafer in Co,welding
sent to a site and asked to explain how you would like a twenty seven flour building should be supplied with lighting and sockets plus a water boiler.
we are going to install a solar PV site and how can we calculate PV Solar Panel Efficiency, can anybody tell me complete method for its calculation.
What are the difference between normal application Transformer and Solar application Transformer?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
how to minimize earth resistance upto 2Ω, if the resistance is 6 Ω ?
redundant connection in contactor?