Interested to Buy Any Domain ? << Click Here >> for more details...
what is the generator rating for 40 amp load of 3phase motor.??
400v voltage of generator...
plz tell me with formula its urgent...plzzz...
and also tell me that this 40 amp at all phases mean 40 amp
on red,40 amp on yellow,40 amp on blue......
or the total sum of that 3phase is 40 amp....
- 7 Answers
- 9451 Views
- I also Faced
- E-Mail Answers
Answer Posted / shocksridhar
In star i phase and i line is same ..,we are using star for distribution transformer so r phase curent and ry curent wil b same nly ..,u must undrstand frst...,
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1.what is the difference between transformer differential and busbar differential.2)why we are using 2 slope for trafo diif and 1 slope for busbar diff.3)what is the purpose of metrosil and stabilizing resistor in high impedance relay circuit.4)how metrosil reduce the peak volage.5)what is the funtion of stabilizing resistor
Hi,I am working in abroad for more than 3 years in a company operating with 11kv and 6.4 MW power. I need c licence in India,can I? some other says only i can get if i work for 2 years in india only! anybody kindly clarify by doubt.Thanks
Why use in ht motore
Determine a suitable number of slors and conductors per slot for the starter 1 winding of a 3 phase, 3300 V. SO Hz 300 rpm alternator. The diameter is 2.3 m
what is the purpose of bypass mode in energy lighting transformer?
Why the field rheostat is adjusted such that the voltmeter reads 380V
what is the importance of Partial Dischage test for Electrical Equipments
What is the criteria for selecting the voltage classes of an AC Induction Motor.The KW rating above/below which ht/lt selection is made may be provided in details.
What is the distance between each insulator in 33kv transformer and how can it calculate
Name of the relay of low lub oil presuure in DG sets
what is the effect of change in supply frequency on load angle of synchronous motor,all other parameters remaining same?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
Is it posible to instal one more SMDB from the existing SMDB and is it practical.
DESCRIBEPNEUMATIC SYSTM OF ASH HANDLING PLANT
What are the advantages of the three-phase motor over single phase motor?
