Resistor switching is used in which type Circuit Breaker
?
a) oil filled CB b) Air blast CB c) Gas filled CB
Answer Posted / anup $ingh
Obviously Air Blast Circuit Breaker
See.. http://www.oocities.org/hemant_thermal/airblastcircuitbreaker.htm
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to do cable sizing calculation for 750 A Neutral Earthing resistor for 33kv. the 33kv cable going to swbd. is 630mm2 3 runs.
In Designing the rating & accessories of a MCCB how to choose the type of releases..means what is the basis for selecting, thermal magnetic, electromagnetic & microprocessr based releases
I have c license but I don't know eligibility of Max Kilo Volts under the electrical licensing board.
what is cascade speed control device?and how this device control the speed of motors?
What should be the percentage increase in length of the dead end clamp for bus bar conductor (Hawthorn) after hydraulic pressing and what should be the applied pressure?
Why does the speed regulating system adopting I controller have no steady-state error? In this single closed-loop speed regulating system, when the input of the I controller Un=0, what is the output voltage of the regulator? What factors do the output voltage depend on?
How to maintain ac plant?
what are the preventive maintanance actions taken for air circuit breaker? please answer me
temp of cast resin 1500kva tx formerwent up to 138.c but came down very fast to about 100.c within 20 mins when load was reduced from 70% to 60%
how to copy from plc ge fanuc versamax series,all input and output, adress, and printout.
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
What are the special cables required for explosion proof wiring?
What is the previous name of Cox's Bazar
WHY TERTIARY OF POWER TRANSFORMERS IS LOADED WITH EQUIPMENTS LIKE CT,PT,ISOLATOR AND CB
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]