Answer Posted / s.ravindra
The condition of dyn1 was
(a) 1W2N+1U2N=1U1W
(b) 1W2W=1W2V
(c) 1V2W >1V2V
Is This Answer Correct ? | 14 Yes | 1 No |
Post New Answer View All Answers
Q.1:What protection will be used on HT and LT side of 33/0.4 KV, MVA transformer. Indicate capacities of protective device to be used. Q.2:Which types of back-up protections are used in the power transformers? What do you understand by the term over travel in the relay? Q.3:How star and delta connected winding transformer are provided from earth fault
What is electrical grounding?
How does "OUT OF STEP" relay ,for Synchronous motor protection, work?
i m electrical diploma holder i want to do plc $ Scada some body tell me which insitute is best for me near chandigarh
What conditions are required for transformer to operate at low frequencies ?
how many electricity poles are there and what are the names and their sizes.
Define sensitivity?
if the load is 80 amp for main fuse and 100 amp for breaker so how can we calculate the cable size (cooper ) .
132/66kv sub-station procation ?
how to avoid Saturation in C.T?
condition Autotrip facia come on control panel of electrical transmission line?
i've iocl interview.. if you know the interview process please give me information..
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What type of wiring series or parallel is used for conventional and addressable type FAS & why?
How to calculat the ratio of HT\LT in energy meter