Explain the advantages of the wheatstone bridge method of
measuring resistance?
- 7 Answers
- 52392 Views
- I also Faced
- E-Mail Answers
Answer Posted / jvino03
Wheatstone Bridge Consist of 4 Resistance.. Out of Four
Resistance three are Standard one.. and one will be the
varying nature.. if bridge is balance only the variable
resistance equal to the standard resistance,.. through
galvanometer we observe the changes...
| Is This Answer Correct ? | 16 Yes | 5 No |
Post New Answer View All Answers
How RTCC panel is working and give single line diagram for RTCC with transformer?
State magnitude criterion.
what is a synchronizing lamp ?
why the colour of insultor stack , petticoat is brown. Is it has some technical reason.
1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating
I have an existing old MCCB. ABB Model SACE, the rating are: Ue = 660 volts, Iu =1250 Amps, 3 poles, Ith (max) =800 amps at 45 deg C. I need a circuit breaker for my 3 phase motors, 380 volts 60 hz. the supplier required the minimum ampacity of the breaker to be 911 amps. can i use this breaker with rating of Iu =1250 amps but Ith = 800amps maximum?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
i have applied for the post of RRB section engineering chennai board please send me previou papers and solved answer. my mail id jagarapusrinivas@gmail.com
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
how does grading rings & spacers in transmission line works? Working Principle?
Why use in ht motore
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
what material is the electrical housing wire made of? is there any difference for the telephone lines?
