Interested to Buy Any Domain ? << Click Here >> for more details...
HOW COULD A SINGLE PHASE INDUCTION MOTOR ROTATE IN OPPOSITE
DIRECTION???
- 3 Answers
- 10455 Views
- I also Faced
- E-Mail Answers
Answer Posted / sanjana singh
SIMPLY INTERCHANGE THE CONNECTIONS OF MOTOR...
EX- PHASE TO NEUTRAL
NEUTRAL TO PHASE
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
in power generator normaly voltagr betwween esth to neutral is 0 but my work place generator show the volatge is 60v any body know why? thanks
what will happen if earth of 33 kv cable (earthed system) is not connected to earthing pit?
What should be the voltage between Neutral and Ground in secondary side of the step down transformer (230 V to 110 V) with no load condition?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
Define phase cross over?
Dry type transformers
What is the role of Dedicated earthing in UPS System?
What is creepage distance..... what will be the value for different voltage level
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
How to assume answer to electrical questions
What is the settings of distance protection relay in 400 kv line
What is the simplest formula to calculate the rotor diameter of a synchronous generator?
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
What is the function of attenuator in cro?
What is the effect of pi controller on the system performance?
