Interested to Buy Any Domain ? << Click Here >> for more details...
what is the difference between 3,4 wire RTD sensor?
- 6 Answers
- 16800 Views
- HTA Instrumentation, I also Faced
- E-Mail Answers
Answer Posted / ng
there is lead resistance compensation in 3 wire RTD, where as 4 wire RTD is idle of lead resistance compensation as 2 wires are used for volt measurement and 2 wire for current measurement.there is no question of lead resistance error, it gives accurate result
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
what is the advantage of submersible level transmitter compare to ultrasonic level transmitter?
hi! i want to know about mpse exam.
Hook up resistance decade box to temp.transmitter.
In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
Difference between ultra sonic flow meter
why Fahrenheit unit of moistur analyzer transmitter
how to calibrate load cell
Can I calibrate the Electromagnetic Flow Meter on line and How.
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
Draw a group of instruments interlocked to a Pump & Motor?
Tell about your IFFCO plant visit.
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?
field bus transmitter calibration procedure tell me
