what is difference between en8 and en24.if the usseage of
motor shaft en8 what problems faceing?and what are the
advantage of en24?
Answer Posted / devender vashishtha
there are many type of material. such as mild steel
(m.s.),en8.en19,en24,en36.en353.
some simple question:-
difference b/w ms & en8
ms is that material which material is not for heat
treatment.its Hardness in nill (approx 20HRC)
& tensile strength 300 mpa approximate.
But
En8 is that material whose hardness increase dueto carbon
%tage.its will go 35-40 HRC hardness.
& tensile strength 600-700 MPa approximate.
2. Difference b/w EN8 & EN24
hardness of these material is approximate same.
But tensile strength of En24 is much more(1000MPa)as compare
to en 8.
so you can say that en8 always better chiose for design a
motor shaft.
Contact me-7836060109(Devender Vashishtha)
Is This Answer Correct ? | 15 Yes | 9 No |
Post New Answer View All Answers
Explain the difference between shear center flexural center of twist and elastic center?
2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand
In which process fluid expands but does no work ?
what type of questions will be there in the written paper of tata motors ?
Explain how can heat be applied to acrylic?
What is the use of rasp file?
What is the difference between Mild Steel and Cast Steel with full chemical composition and application details.
What is diffrence between star & delta connnection in practical situation in submersible pump?
Which reactor uses heavy water as moderator ?
What is the sensitive part of the liner
Why are not use ball bearing insted of roller bearing?
What is railroad track ballast?
What causes damage to impellers?
The capacity of a domestic refrigerator is in the range of ?
What resistance the ship encounter when the vessel is at sea