Interested to Buy Any Domain ? << Click Here >> for more details...
in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 18 Answers
- 43468 Views
- Eaton, Siemens, I also Faced
- E-Mail Answers
Answer Posted / balaji
the reason is to avoid the losses
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Should power factor be low or high?
Why the arms of delta in a delta-wye power transmission system are kept constant??
Explain how to determine capacitor tolerance codes?
is it possible to start a motor in felid connected to a remote mcc
Why use in ht motore
What is the difference between rulling span and wind span of of an Over Head Transmission Line?
State ohm’s law?
What is the difference between indoor and outdoor transformer
What is inrush current? how can calculateit? what is the affect of it?
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
one split ac how can told of this ac which Tr tell me us
List examples of current sources?
I have doubt that the supply HZ (very low or high than rated ) may affect the power factor. is it true. ?
what is the relative size of single and three phase?
what is the voltage rating of chiller unit sensors
