Interested to Buy Any Domain ? << Click Here >> for more details...
what is the breakdown voltage value in BDV test in
transformers?
- 6 Answers
- 36978 Views
- Siva, TATA, I also Faced
- E-Mail Answers
Answer Posted / kishore
the minimum aceptable value of breakdown voltage in BDV
test is >30KV
| Is This Answer Correct ? | 15 Yes | 6 No |
Post New Answer View All Answers
Power Factor Correction Panel (Manual & Automatic)
new 90kw motor installed so how I purchased cable ,fuse,etc please give me technic for cable selected why always capacitor delta connection
how flow current in 220 kv line to line
What is Instantaneous Earth fault relay,how will work
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT SWITCH BOARD,MLDB,ACB,BUSBAR,ETC...?
i have a 4 Mva transformer 34.5 kv / 480-277 v and i used 2 parallel 3200 amp bus duct for the secondary feeder using 3 ply of bus bar ( 3/8" x 5" ) as a common where the flexible link terminated and 6300 amps breaker for the main, the lower bus duct reaches 70 degrees and the upper bus duct reaches 55 degrees when i used thermal scanner. why the temperature is not balance when the load reaches 3600 amps.
Why mostly the HV side of transformer has Delta?
I have a situation to design sub-Distribution board/Panel meant for feeding power sockets. In the incomer CAN i Take TP MCCB with Neutral Link and All the outgoing feeders with to sockets with TP MCCB and Neutral Link? P.S : My System is IT Earthing
If I want to connect a capacitor bank on the HT side of a 11kV/415V, 3 phase delta-star distribution transformer to supply Reactive power to it..what practical specifications of a Capacitor bank that can i've??please reply..
what is the difference between surge protection capacitor and surge arrestor
Is there any reason that we get shock on touching phase wire because the earth is at neutral potential? Is there any reason that the earth is at neutral potential because the neutral is earthed in apower station
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
plz send me HPCL apptitude paper.. maulik_elect@yahoo.co.in
why can we use cosine wave instead of sine in ac supply as both have same rms vale and ripple factor
sir please tel me how calucalte kwh if home taken load 30ams how maney kwh taken per day.and 3phase motor 5hp per hars how maney load teken and how mach kwh and forward me to electrical table for calicalte kwh and kvr and kvah
