What should be ideal IR value for 11kV, un earthed, 1 MW
motor?
Answer Posted / sunny saini
ANYONE MUST FOLLOW THAT THE LEAKAGE CURRENT MUST NOT
GREATER THAN 1ma FROM PHASE TO GROUND.
SO
IR (MIN)= 11000/.0001=11MOHMS
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Is it possible to make a 5P10/ CT Ratio 50/1A Burden 5VA
XYZ
After doubling voltage from solar cells & use step down voltage transformer can we get high current output with low voltage.
Testing report of Earthing of 3.15 MVa PTR.
WRITEDOWN FEW RELY CODES
why dc is used in control circuits for MV & LV switchgeras instead of ac
describe the fully control circuit diagram of ac drives
what is the mechanism of operation of brushless dc motor why is it more wexpensive then ordinary permanent magnet motors
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
when generator short circuit condition, the current how dissipates. or at short circuit voltage not available then current how can flow?
i wasted one year for the job after completed my btech what can i say about 1year time in interview
How much load can be taken for chiller from 1500 kva transformer
Either It Possible a dc Motor to Run On Ac Drive [ Ex : ACS 800 , Yaskawa F7 ] If it is Possible How Pls Inform Me dinesh_elect_eng@yahoo.com
what is the difference between switch yard to residential area.and how much required it.
What OPGW is better than Microwave or PLCC???