What is difference between PVC cable & XLPE cable?
- 14 Answers
- 193858 Views
- Intertek, I also Faced
- E-Mail Answers
Answer Posted / leeladhar kashyap
XLPE got more Capacity to hold on incise of high temperature. XLPE will not deteriorate it's insulation property until it reaches 90 degree centigrade. it will not suddenly loss it's insulation property if the temperature jump above 90 degree centigrade, but the overall life of cable will be reduced. PVC can withstand temperature only up to 70 degree centigrade.
PVC is cheaper then XLPE.
PVC is thermoplastic whereas XLPE is thermosetting plastic.
PVC= poly vilyn chloride & XLPE = Cross link polyethylene.
| Is This Answer Correct ? | 18 Yes | 2 No |
Post New Answer View All Answers
what is the difference b/w absolute encoder and incremental encoder?
Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????
why sometime we get electrical shock while touching the ballon of dish tv connection ? which we should not get.
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
can any one suggest me the tilt angle of my solar pannel ?? or tell me how can i know the fix tilt angle of my solar pannel?? my cordinates are 31.503629,72.993164.
What is the diff. between single compression and double compression gland
What is Annunciation?
how to produsing geretor power
How to connect the chemical earthing and complete process tell me plz
What is the difference between in Fourier series and Fourier Transform. and please tell me the difference between both of them and the why we use them in communication system?
what's producer of XLPE cable laying in undergroung
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
What are the different types of dams?
Why power factor should not be in leading (capacitive) mode of any load.
What is an automatic controller?
