8mm steel not
available at site
used bar 8mm and
150cc please tell
me specing i used
10dia bar write
formula please
Answer Posted / ujjawal u daharwal (sgsits, in
very simple
Note: d1^2/s1 = d2^2/s2
where, d1= dia of available Bar
s1= spacing b/w available
d2= dia of new bar
s2= spacing of new bar
in this case; d1= 8mm, s1=150mm, d2= 10mm &s2= ?
8^2/150 = 10^2/s1
s1=234.375 mm c/c = 230 mm c/c ANS
Is This Answer Correct ? | 8 Yes | 0 No |
Post New Answer View All Answers
What is binding spacing of the rebars at lapping zones.
how to caluclate sienerge qty in construction in ap
How many pyramid in egypt?
What is reinforced concrete?
IN Compression testing machine 1division =10KN ,then what is compressive strength of 100*100 mm cubes at a load of 320 KN
As we know that steel is a tension member but why we are using STRUCTURE STEEL as a COLUMN (Without concrete) where column is a compression member and compression strength of steel is very low
What is Refuse Area In High Rise Building ?
1:4:8 pcc calculation 591 cu.ft
How is improve my knowledge in construction industries....
What is zoning permit?
A sieve analysis results in 100% retained in no. 50 Sieve, the fm is?
how gradation of aggregates effect on slump of fresh concrete?
For elevated service Reservoirs what will be the output of each skilled carpenter and bar bender.
the water is flowing through a velocity of 1.5m/s in a pipe of length 2500m and dia 500mm. at the end of pipe a valve is provided. find rise in pressure 1. if the valve is closed in 5 seconds. 2. if the valve is closed instantaneously. take value of c = 1460m/s, pipe to be rigid and bulk modulus of water - 19.692x10' n/sqcm
How to calculate brick work quantity?? Block work quantity??