Interested to Buy Any Domain ? << Click Here >> for more details...
Can DP transmitter with orifice plate works on Beta ratio
0f 0.3 and differential pressure of 100 MMWC in liquid
service application?
- 1 Answers
- 5094 Views
- I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
An orifice plate (OP) creates a pressure drop in the flow
stream.
The question is whether an orifice plate 'works'. Works how?
An orifice plate will always 'work' by creating a pressure
drop; the proper questions are whether the permanent
pressure loss is excessive, whether the orifice plate has
been 'sized' for a specific medium at correct design
conditions, and whether the pressure drop (DP) is adequate
for instrumentation that senses the DP.
Orifice plates typically drop 100 inches water column at
100% flow rate, about 25 times the DP of 100mm water column.
A DP of 100mm water column at 100% flow rate is more
typical of an averaging pitot tube than an orifice plate. A
full scale flow rate of 100mm w.c. requires a low range
pressure transmitter, or one with a high turndown ratio.
A 0.3 Beta is acceptable.
Carl Ellis
Measure First
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
Explain the difference between plc and cnc?
is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?
POSSITIVE PULSE IS APPLIED TO AN INVERTER INPUT.THE TIME FROM THE LEADING EDGE OF THE INPUT TO THE LEADING EDGE OF THE OUTPUT IS 10 ns. THE TIME FROM THE TRAILING EDGE OF THE INPUT TO THE TRYLING EDGE OF THE OUTPUT IS 8 ns. WHAT ARE THE VALUES OF tPLH and tPHL?
What is the diffrence between ff tx and non ff tx
flow transmitter formula?
can any send me a forbes marshall dtron 316 manual
line up procedure for dp type flow transmitter?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
What is rang ability?
what is the usage of QDV & VOLUME BOOSTER
how is work pressure switch& level switch?what is the principle of this?
what is a good line as ic engineer as maintenance ,oc, project, calibration ,validation engineer?
what are the steps I have to deal with?
Please asked me How calculate DCS controller memory.
Name different parts of a pressure gauge.
