Interested to Buy Any Domain ? << Click Here >> for more details...
what is power factor ? why is it so important?
- 2 Answers
- 7044 Views
- Telco, I also Faced
- E-Mail Answers
Answer Posted / ghulammohyhuddin
what is power factor
apparent lode and actual lode is power factor
why is it so important
this is very impotent because control mager demand
that min is if your lode is govt 100amp approval if is
goning to 120 whan to start motor or etc will be amp high
for a second . this will be meter record in meter
electrical company . so power factor work is leed or lage
in this mater . whan lode is going up capastor is working
sablish the voltage and crrent not gonig up ,
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What are the two types of compensation?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
What are the Return ( Monthly / quarterly/ Annual submitted to Electical Inspector for an establishment (Factory in Maharashtra-- Small scale category having seperate HT line of 22KV ) as per Maharashtra Electricity Act
why we used dc supply for field in dg set
sometime battery charged and then automatically charged when rectifier ON conition, is there any chances please clarify the same.
aternator every parts and its working
what is the earth current,reverse power,electrical trip generator short circuit,low voltage, high voltage please discribe me
WE HAVE THE DC RECTIFIER 1500A, INPUT VOLTAGE IS 3 PHASE. HOW TO CALICULATE THE LOAD? 3 PHASE SIDE EITHER dC SIDE. PLEASE SUGGEST ME
Is it required to do earthing in 2nd shop if earthed armoured cable is laid from 1st shop ?
how do we calculate length of starting time and repeated starting of a direct online starter?
State the methods of improving power factor?
i want to run 11kv star connected motor in 6.6kv with delta connected throught inverter, is it possible?
Dear All, I am new in construction company , my boss ask a question at time of interview , If we have 60MW generation and Single Power Transformer step-up we have. if CMR 50/60MVA , ONAN, ONAF respectively , is it sufficient or not ? for that much power to transfer,
What is meant by stator? What is meant by rotor?
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
