a 3 phase slip ring induction motor is wound for 4 poles on
stator and 6 poles on rotor; when 3 phase balanced voltage
source at 50 hz is applied to motor it will run at
a)1500rpm b)1000rpm c)750 rpm d)zero rpm
Answer Posted / pramit dutta
i think the question is incomplete ,
we know n=(1-s)ns , so, ns=(120*50)/4=1500 rpm.
so we need to know the slip of motor then we find answer.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in shunt clippers why a resistor is used in sereis with the input
Why water bubbles when D.C. Current is passed through it? Why not when A.C. Current is passed?
For the requirement of a furnace of temperature range up to 1200 oC using silicon carbide rods, What is the required rate of transformer needed (please do it with all details)?
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
give me applications of sequence bridges . (used in 3 phase un balanced systems)
what is the correct method for the outdoor termination of 19/33 KV HT cable step by step?
DG Earth Value?
what is the saturation point of crgo lamination.
How to calculate pitch, gauge of winding wire, and No. of turns for 30HP, 3 phase, 4 poles 50Hz, 380V induction motors
What is K-rated transformer? What is the use of it? What can be the size(pls provide calculation if possible) of K- factor transformer for 550kW,690V motor operating with drive (VFD)?
acb(AIR CIRCUIT BREAKER)NOT CHARGING AUTO
How many Zones can be in Conventional type fire alarm system & how can we detect the fire in Conv. type FAS?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
how to find three phase complex power in per unit and MVA?
How to calculate no of Lighning arrestors are required for protecting 50mX 50m*20m cubical building and locations of LA?