when the motor was star position that is running ok but when
the motor was delta it was tripped? why?
Answer Posted / santosh kumar kishore
in delta connection motor takes more current and in star
position motor takes less current so either change
connection or increase relay setting.
Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
difference between ac series and parallel circuit
write a c++ code that receives an integer number and display the sum of the number and its revers integer?
How to calculate the phase to phase clearness of HT /// LT bus bar?????
WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.
Keywords: Die, Card, Coin, B/N 2 To 12
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating
limitation of conductor height on ground when we consider EMC
where we use the SFU & FSU?
we are having 110 Kv,250mA Electrostatic precipitators for coal fired boilers. what will be static voltage and current after discharge and what time it will remain before earthing?
Why we use 4-20 mA Analog signal for the PLC input? Why not 0-20 mA? Why not 5-25 mA?
How Load Factor, Demand Factor, Diversity Factor etc best applied in designing an electrical circuit? Is it allowed to consider these factors in each and every panel in an electrical distribution system? Can any body suggest a good book for reference?
What Is Connection APFC Panel In Compony.
how to determine motor size for a fan application?
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
How much current will a 5 HP delta connected motor at no load will take?Is tat need a starter