how the lap length is calculated in reinforcement of 110mm
dia steel of Length 15.00 mtrs. & grade of concrete is M20
- 22 Answers
- 99684 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / pawan mistry
For Steel Dia above 32mm lap is provided by weld only.No lap
will be aloowed.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is the difference between one-way slab and two-way slab?
Define What is passive earth pressure ?
contractor receive 100 MT steel.after compliting the work the contractor refund 90 MT steel.How reconsilation of steel done?
1)What is the total volume of aggregates required for 1cu.mtr.solid hard concrete? 2)What is total mass of wet concrte and dry concrete after 28 days of M25? 3) Is 28 days strength is the final strength of concrete or it gets increasing as the time period increses.? 4)What is the volumetric proportion of concrete grade of M25.M30,M35,M40
What is the standard unit weight of Cast Iron pipe of 200MM Dia.(pipe specification is IS1538)
what is tension column?
How to make a c++ program that converts any base to base 10?
A rock anchor 3 1/2” in diameter is placed in rock. The which has an allowable shear strength of 1200 psi. Determine the required anchorage length to safely carry a 80 ton load using a 2.0:1 F.S
How reactor of SBR installed , is it be over ground, fully under ground or semi sunk ?
which steel is better for residential building tmt steel or hysd steel
What are the advantages of building a dam on the river nile?
How to calculate paint drums per meter square
What are the advantages of cad?
The foundations are placed below ground level, to increase?
what is the water cement ratio of 1:6 and 1:4 cement sand mortar. reply soon
