what is the difference between LT and HT power supply?
- 26 Answers
- 178750 Views
- Center One Mall, Central University, JSW, Siemens, Suzlon, I also Faced
- E-Mail Answers
Answer Posted / himanshu
LT power supply up to 415 volt, where as HT power supply is
above 415 volt & up to 220 KV and above 220 KV it is EHT.
| Is This Answer Correct ? | 12 Yes | 4 No |
Post New Answer View All Answers
what is package substation.how many types they have
HOW WE CAN REDUCE THE CIRCUIT COMPLEX OF STAR-DELTA STARTER .BECAUSE NOW WE USING ONE TIMER RELAY & THREE CONTACTOR FOR MAIN,STAR & DELTA ?IF ANY IDEAS PLZ POST.THANK U
what happen when increase or decrease size of lamp,light.glass.
We have received supplies of the ordered material. payments against the supplies also released. Where ST paid 4% against form C. Meanwhile it has been observed that 25% of material supplied was defective. Please suggest whether the issuance of C form from our side would be stopped till settlement of liabilities.
Why is a synchronous motor always star connected??
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
am commissioning the trafo without connecting the neutral therefore unbalance will occur what is the alternative solution for this?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
State kirchoff current law?
Why armature rheostat is kept in maximum position?
Why auxiliary transformers are not connected in parallel in primary stations?
1)we have 1000 cfm Blower,Dia-1Mtr,Velocity of air 94 m/s 2)We have Natural Air velocity 94m/s 3If i Put Wind Mill in natural air ,speed is 94m/s Then it will generate Assume 100kw 4)If i put same wind mill across the Blower,air speed is same 94m/s now the Question is Will it generate 100 kw?
what is automatic voltage regulator?we can control the vlotage by using fuzzy controller in matlab?why we go for fuzzy?
1. for eg, capacitor is used for many purposes(it act as filter, oscillator, bypass capacitor, memory storage etc...) 2. Please tell me some example circuits for different uses of capacitor( whenever and whereever and however we used capacitor as a filter, oscillator tuning etc..) 3. similarly for inductor and resistors(it act as what?) and when and how we want to act as like that?, and how we can used these components depends upon our requirments with example circuits and explanation? design to act as these components depends
Explain the difference between verilog task and verilog function?
