Answer Posted / sagar tiwari

lap length formula=d*50=mm

for example=12*50=600mm is the lap length of 12 mm bar

(d is the dia of bar)

What was asked in isro civil interview

1102

---

how to calculate valuation for the old building?

2377

---

I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.

6058

---

can we find any technical issue if we are gong to change the dimensions of steel beams from one type to another type IE if there are any equievelant data base to find solution for problem of changeing sectios of beam from one type to another with the same cross sectional area.

2031

---

What is meant by autocad?

1199

---

For a washout valve why are two gate valves required in normal practice?

1128

---

afe or not

2157

---

What is demising walls?

1147

---

WHAT IS YOUR CURRENT SALARY

2235

---

do you think we shall remove un wanted soil for foundation excavation even if the thickness of the soil strata is more than 8m ?

1652

---

Will going from a 3-tap to 6-tap increase water pressure?

1046

---

Design a cantilever type retaining wall to retain sand for 4m above the ground. The sand fall slopes at the rate of 1 vertical to 2 horizontal. The weight of sand is 18000 N/m3, the angle of repose being 30. The safe bearing capacity of the soil is 200 kn/m2 at 1/25m below the ground level. Use m 15 concrete mix.

2817

---

how to calculate quantity of cement,sand & aggregate for u.c.r / r.r masonry in cm 1:6

6222

---

How to calculate laplength for 3 floors

1863

---

how to calculate 1:5:8 ratio concrete cement, sand, metal and water please give me brief calculation

1734

---