Interested to Buy Any Domain ? << Click Here >> for more details...
If I want to use capacitor banks at HT (11 KV) side for
maintaining power factor then which type of capacitor
should I use? Plz give me the specification?? (I am using
1250 Kva transformer (11 KV/433V)).
- 2 Answers
- 10576 Views
- I also Faced
- E-Mail Answers
Answer Posted / swaroopreddy
use of capacitor at HT side may be usefull if installed at
distribution yards, but it will be very much use full if it
is at load end, which redeuces line losses
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
What is nichols chart?
# 4 hi friends i m from electrical branch and seeking for tech. + apti. both papers of hpcl plz get it available as soon as possible my email id is sumit_lig189@yahoo.co.in
How do we calculate the Out put voltage of generator, after the excitation is being given?
What are high pass filter and low pass filter? and What are the flowmeter ?
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
How good are you in resolving the commercial issues to Employer's advantage?
What is difference between start imitation and start interlock for 3 phase motor protection ?
when the Transmission and Distribution network where is the "feeder" lines are located? and why should be used in T&D network.....
What are the different types of dams?
What is accuracy of a measurement?
What is MS-EXCELL?
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
How to identify the start and end of 3phase 12 lead motor if U1, U2, etc numberings are lost or erased.
How earthing/grounding done in aeroplanes and ships.
