Interested to Buy Any Domain ? << Click Here >> for more details...
I am working in a process industry, in that there are
several sections devided in the SCADA screens and
individual sections may START independently. But sometimes
i am facing problem i.e, if section 2 Stopped by the
operator immediately Section 1 or Section 3 or Section 4 is
getting stopped can you expain the reason behind this?
- 5 Answers
- 6409 Views
- I also Faced
- E-Mail Answers
Answer Posted / sks
this might be due to 2 reasons :
1)scan cycle of the processor has been increased anyhow as
the Dword value is updated after the signal is processed in
module. this extended scan cycle causes difference of
process values on HMI
2) check LAN ports of all stations and also the patch board,
if there is option for redundancy check the healthiness of
redundancy.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
for oil & gas industries which zone is normally preferred? why? give its example?
how to calculate orifice sizing? and tell me if pipe size bet 50mm t0 200mm then we can use pipe flange??? and above 250mm pipe size should i use D & D/2 Flange? is it right or wrong?
IS there any effect of vortex in low pressure side of the transmiter after the orific in feed water line? if yes then what is the calculation?
which type of zones used for boiler? & why ?
hi,i am doing 3 year in electronic and instrumentation engineering. what type of aptitude questions will be asked in a core industries and how can i improve my skills in instrumentation?
Instrument QA/Qc what is the project quality plan?conduit inspection RFI. which documents attache with package?
Explain the working of an electronic level troll.
i have used level transmitter in starch cooking preparation tank. tank total height 2mtr.sometime LT display shows some error value when tank is fully empty and diaphragm side i already checked okay no problem in diaphragm area. field cable checked 24volt and mA shows correct value while tank empty mA is 4mA. 4mA i needed that 0% but display showing 10% or 15% percentage values are varying continously please give any good solution for me.....
How does temperature bath work? How does coil gets heated only by applying some current?
Explain bernoulli’s theorem. State its application.
How it the difference between force balance system and dispalacement balance system?
How to calibrate an pressure gauge with yantrika test bench?
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
How can a d.p. Transmitter be calibrated?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
