What is the diffrence in between Class PS & Class 5P10 for
CTs
- 7 Answers
- 8874 Views
- I also Faced
- E-Mail Answers
Answer Posted / jonnalagadda chowdary
PS Class CTs are used for Differential,over current
protection(direct protection) & 5P10 are used for restricted
earth fault(indirect protection)
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what happen when power factor of 2 parallely operated transformer become equle?
pls tell me about ups internal connection & we have given only 3 phase supply to ups system how get 4 wire (R Y B N )
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
which connection is safer series or parallel?usually which connection we prefer at home?
What are dcs and plc?
IF % IMPEDANCE OF A TRANSFORMER IS INCREASED FROM 5.8% TO 8% HOW MUCH THE EFFICIENCY OF THE TRANSFORMER WILL COME DOWN?
HOW TO CALCULATE AMPs OF CURRENT TRANSFORMER IN HT Panel
what is invertor supply and raw powersupply
can anyone give an idea about dia calculation in cold rolling mill
what are the steps involved in generator load test?
what is the most permissible winding temp when we conducting a generator load test?(condition no load)
Usage of flywheel diode in relays
What are the three types of compensators?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
Why is a synchronous motor always star connected??
