What is meant by Anchorage length? Development Length?
- 10 Answers
- 100558 Views
- HSCC, VHR, I also Faced
- E-Mail Answers
Answer Posted / alehegn yehuala
Basically the development length is the length which should
be such that the stress should develop on both sides of the
point of maximum stress in the steel bar. If this point is
in the mid span of the beam then it can develop on both
sides but if the maximum stress is at the end (like in
cantilever) then we need to provide extra length beyond the
end support center line. If this extra anchoring length is
straight which is not beyond the nominal cover of the end
support then its same as development length and if this
extra anchoring is beyond the nominal cover of the end
support, then it is not straight bar i.e. with hooks then it
is called as anchorage length which is used to provide full
development length & an additional length for stability of
the structure.Therefore it is the anchorage length must
provide to detail any structure which have the same
situation as described in the above rather than development
length.
| Is This Answer Correct ? | 31 Yes | 6 No |
Post New Answer View All Answers
I HAVE APPLIED FOR 20TH UES ARMY. I WANTED TO KNOW WHEN WILL I RECEIVE CALL LETTER FOR THE SAME.
how can we calculate steel value, depending on load
While calculating the weight of the steel per running meter, the formula used is [(dxd)/162]. Why 162 is used in denominator & how it is derived?
what is the 0 value in quantity surveying
400 ku d/c clearess ketan hota hai?
5. Two long boundary walls run parallel to each other at a center to center distance of 1 meter apart. The width and height of the first wall are 0.30 m and 2.5m respectively. While those of the second are respectively 0.18m and 3.5m. Plot the distribution of vertical stress intensity due to walls on a horizontal plane, 1m below ground level. The walls have negligible depth of foundation and are made of brick masonry (y = 19.2 kN/m cu)
please send me bhel questions on rupesh.017@rediffmail.com
What is the strength of 1:6:12 mix?
pls mail some more tecnical qustions at msaranya2610@gmail.com
can u plz send me ntpc placement papers(civil engineering) at mohit_verma21@yahoo.com
How much area, in square meters, will one liter of paint cover if it is brushed out to uniform thickness of 100 microns?
PLS.......... ANY ONE CAN FORWARD ME PREVIOUS QUESTION PAPER hpcl civil engg
HOw much % of premium on DSR-2013 currently
pls send me interview question paper with answer of EIL/AAI/UPSC/RPSC because i am doing prepration of compitation exam of UPSC for the Asst. Executive Engineer
Draw a neat sketch showing the 'throat' of a welding in a plate girder ?
