We are having a 2000KVA DG set. It trips with Over speed
and Engne Hot when the mahine is stopped in full speed. How
shall I analyse the block load and reverse power.Is the
problem related to power factor. The machine which runs on
this DG is having all Synchronous motors with incividual
Drives.
Answer Posted / k.prakashchandra
Throw -off at full load results in high speed before the
governor controls the speed and also overheating
Is This Answer Correct ? | 1 Yes | 2 No |
Post New Answer View All Answers
How to Calculate The sag of OPGW in Transmission Line???
what is upper impedance and lower impedance of a distance relay
how could we know the size of cable by physical view?
What difference between ref protection and differential protection ?
in ring main system we use the isolater b/w transfer bus and main bus if we r not use isolatar than wat will be the effect in our sys.
show the single line diagram of star delta starter with single phase preventer
explain Density
detailed procedure how we calculate cost for pcc m10 and rcc m20 including centering and labour excluding steel/ iron
if we apply 1000ADC instead of 100ADC or We apply 50ADC instead of 100ADC,What will be happened in the test result value.Pl explain
FEINGING DECREASES THE FLUX DENSITY IN THE AIR GAP. HOW?
why chock were used in old tubelights but are not newest tubelights?
what is the power factor used by the PHCN in nigeria? 2. what is the difference between an alternator and generator. 3. Generation of poweris in KV but how is transmission is in MW. 4.If the transmission of power is 20,000MW how can it be increaesed to 80,000MW
What are the types of windings according to the construction?
what is the use of the circle diagram
what r PID controllers?why they r used?what is there purpose?plz Explain in detail