Interested to Buy Any Domain ? << Click Here >> for more details...
What is difference between MCB,MCCB,ELCB and RCCB?
Brief description and why RCCB is costly?
- 3 Answers
- 9695 Views
- JLL, I also Faced
- E-Mail Answers
Answer Posted / g.t.manikandan
MCB is miniature circuit breaker which is thermal operated and use for short circuit protection in small current rating circuit,Normally it is used where normal current is less than 100A,
MCCB moulded case circuit breaker and is thermal operated for over load current and magnetic operation for instant trip in short circuit condition,Normally it is used where normal current is more than 100A.
RCCB is used to detect earth leakage fault.once there is a ground fault in the load side,current from phase will directly pass through earth and it will not return through netural through RCCB,that means one side current is going and not returning and hence beacuse of this difference in current RCCB will trip and it will safe guard the other circuits for fault loads,that why cost of RCCB also costly
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
What is meant by impedance? difference between high & low impedance ?
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
a starter used for squirrel cage induction motor?
What is meant by short-pitched winding?
the typical output of a solar cell is........
what is kondo syatem in eletrical traction
WHAT ARE THE CHARACTERISTICS OF AN VOLTAG AMPLIFIER
why and how current drawn by battery charger depends upon the altitude where it is located?
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
1) why a dg set shows variation of power factor and load when synchronised with other dgs? 2)Why the load sharing is not become equal in all dgs?. 3)When a dg set will not run on auto start?
why do we have spikes enough to burn electronic boards, when generators are not grounded
how slip power recovery system work
Two bulbs of 100w and 40w respectively connected in series across a 230v supply which bulb will glow bright and why?
What is the basis for framing the rules of block diagram reduction technique?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
