Interested to Buy Any Domain ? << Click Here >> for more details...
what is the main purpose of line PT and bus PT?
- 11 Answers
- 83152 Views
- L&T, I also Faced
- E-Mail Answers
Answer Posted / v.doraiswamy
Line PT:The Line PT is located on line side of the Feeder.
This will have normally has two secondary cores.The core
with accuracy cl.1 is used for metering purpose(ie)
measuring Voltage,watt,var etc. Core with accuracy cl.3P is
used for Porotection like distance scheme relay,
directional O/C,E/F relay. Also metering secodary core is
used synchronising the line with Bus.
Bus PT : The Bus PT functions are same as Line PT. But This
is located on the main Bus and this can be used for all the
circuits being located in the Bus. For cost point of view
it better to have common Bus pt for all the circuits.
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
How to calculate capacitor bank value to maintain unity power factor with some suitable example?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
Why the dc voltage drop during starting of emergency lube oil pump? The Voltage drop from 135kv to 125 kv for one min. before re-establish to 135kv?
Define phase cross over?
What happen Grid EARTH plat got cut.
what are the maximum available current, voltage ratings and switching speeds of the power electronic devices thyristor, power mosfet, igbt, and mct?
RATING OF LIGHTENING ARRESTER FOR 11 KV LINE IS 9 KV is ok ,but haw to calculate the KA rating?
What is a DC series motor?
How can a equal potential zone be carried out in conductors?
What do you mean by pull of electromagnet?
what is mean by parallel operation of permanent magnet generators
What are high pass filter and low pass filter? and What are the flowmeter ?
Why single phase induction motors are not self starting ?
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
