Interested to Buy Any Domain ? << Click Here >> for more details...
why name plate detail HP/KW rating of a motor is different
from measured value HP/KW using formula?
- 1 Answers
- 5120 Views
- MAHINDRA, I also Faced
- E-Mail Answers
Answer Posted / simon
The name plate detail HP/KW rating of a motor is in standard conditions.As result its always vary.
| Is This Answer Correct ? | 5 Yes | 4 No |
Post New Answer View All Answers
with out colour codeing on conductor how can be find what is r,what is b,what is y phases.....
What is ideal IR values for ground and neutral.
For some transformers we are using solid neutral earthing while some others we are using resistance earthing why ?
can we use NPT glands in LT panel
What technology is used in latest generators?
We have Diesel generator of 200KW. fuel consumption is always same,even connected light load or full load. Is it right?
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
How to calculate per unit impedance of transformer?
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
What is the most accurate way of testing ELCB?ELCB is better than RCD?
What is Bolted fault?
What is evaporator & condencer & compressor
Explain the working of variable frequency transformer?
what is V.L.F. testing of power cable? do you know the voltage ratings, like for what rating and size of cable what rating of V.L.F. testing is used?
