what are the 6 terminals of the motor plss give me in
details
Answer Posted / simon
You have a 3Phase motor.It has 6 terminal.3 above & 3 below.
Now you can mark A-1(LEFT HAND SIDE)to the upper terminal,
A-2 to the Lower terminal Like wise B-1,B-2,C-1,C-2.
Now if u want to make DELTA connection then with the help of a wire connect A1->A2,B-1->B-2,C1->C2.In star connection with wire short circuit A1->B1->C1.
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
what's prime importance of protection in electrical system.if protection system don't work properly what can happen in electrical system?
Dear Brother can u tell the proper size selection of cable & the fault level calculation of braker, busbar etc. pls mail me at azeemk30@gmail.com
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
What will be electrical cost per sqft for IT building (basebuild and fitout)and for residential township?
Cables Construction hi friends, 0.6/1/1.2 kV LV , DC and Control cables are concentric copper conductor what does its means and what is the use of concentric copper conductor,and are this with copper tape shield or copper screening, ? thanks
Differentiate between kirchhoff’s first law and kirchhoff’s second law?
Can we use 230VAC, 63A MCB for 120VAC, 63A supplied heaters load?
WHY IL=IPH IN STAR AND WHY IPH=IL/1.732 IN DELTA? WHAT IS REASON BEHIND IT?
our factory is going under construction mean time transformer 1000 kva 2 nos &load break swithch 12 kv & 4 nos 750 kva 2 nos & 380 kva 2 nos generator to be errcted.how to arrange earth pits &how to earth connect & neutral pit how to calculate in earth bit size.
Why 30kw 40 hp 4 pole 3ph induction motor over heated?any steps on reduction in heat?
during installation time of transformer and alternator which points we have to observed?
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
what & how to check the lightning arrester
Why we use circular(Stepped) cross section in transformer core?
The specific heats of the gas at constant pressure and constant volume are respectively 1.0 kJ/kg K and 0.72 kJ/kg K; the value of R for the gas is