Answer Posted / vipul kumar rai
W=1.732x380xI
30x1000=1.732x380xI
I=30000/658.16
I=45.581 ( FOR THE PRIMARY CURRENT )
W=1.732x220xI
I=78.731 ( FOR THE SECONDRY CURRENT )
Is This Answer Correct ? | 1 Yes | 3 No |
Post New Answer View All Answers
What is the difference in calculating size of AC cables compared to calculating size of DC Cables? Usually DC Cables are larger than AC Cables although they have the same ampacity. Why is it?
how 650 volts creates? where is use?
What is the working principle of CFL & T5 tube light & 40W tube light with electronic ballast?
I have made a 3 phase thyristor full bridge rectifier. But at the moment it is working only for the half bridge operation. Both the half bridges are on operation separately but when i put it into full bridge operation the oscilloscope output is zero. I rechecked that the pulses are correct for each thyristor. what could be the possible reason for this?
What is the basis for framing the rules of block diagram reduction technique?
How much pf maintan in dg set in 6o% load,when Dg runnig Neutaal Earthing removed what happen.
What is reverse power relay?
What is highest size of HT motor like 11 kv or 33 kv,and how to make it 750 rpm.i think the size will be very big.any idea ? pl. reply..
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
why magnetising curve not start with zero voltage?
1.how many types of relays? 2.difference between ATS& STS?
What is dynamo?How it works and what is the function of dynamo in a DG.
What descriptive information does the NEC require to be marked on all conductors?
What are merits & De-merits of State-Space Method? What is series programming, parallel programming, general programming & direct programming ? And, difference between these programmings Techniques ?