how to calculate Amp, 2 different Amp of batteries?
Example:
No. of Batteries = 2
Battery voltage = 12V
1st Battery rating = 17AH
2nd battery rating = 30AH
between parallel connection then output volt
12v
Amp?
- 2 Answers
- 4482 Views
- Bhel, LG Soft, I also Faced
- E-Mail Answers
Answer Posted / simon peter
In parallel connection output will b 12v 47ah.....
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how we findout a ignater is faulty or not?
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
What is meant by celling voltage & current in excitor ?
A 100KVA SINGLE PHASE TRANSFORMER 10000/200V,50HZ REQUIRES 300V AT HV SIDE TO CIRCULATE FULL LOAD CURRENT WITH LV SHORT CIRCUITED.THE INTAKE IS 1000W.THE % OF REGULATION ON FULL LOAD AT 0.8 PF LAGGING WILL BE HOW MUCH AND THE SECONDARY TERMINAL VOLTAGE ON 0.8 PF LEADING WILL BE
hello!my name is sheikh iam preparing for indian engineering servieces,please send me the old question papers..to sheikhshaazforjobs@gmail.com
what should be the no load current for 3 phase ac motors ranging from 5 kw to 1000kw?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
What is the difference between type1 and type2 relay protection co-ordination for motor feeders
Why insulation level follows this order? transformer < bus bar < circuit breaker & Isolator < transmission line.
can i connect the two phases of scott connected transformer,if not why?
what is acceptance test in electrical engineering.
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
How to size Air Circuit breaker (ACB)? What is the most important factors?
how we can calculate chiller required ampear?
why co incidence factor considered in transformer sizing?
