what is the difference between transmitter and smart
transmitter ?
Answer Posted / md. afroz alam
In smart transmitter we can change the range,type,tag number,process variable,unit,linearity or square root etc.It is microprocesor based technology.It has self diagnosis capabilities.It is quick service.It is communicate by remote place.It is callibrated by hart communicator .
Is This Answer Correct ? | 15 Yes | 1 No |
Post New Answer View All Answers
Can any body tell me about SAP MAINTINANCE MODULE. WHAT IS its function and application. And study material Source about it. I shall be very thankful.
What is the purpose of bypass valve across AS valve.
What is the start up procedure of desalter
how to commission furnace ( water heater)
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
Explain bernoulli’s theorem.
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
How to measure the dust in chimney(spm)?
what is use of communication wire in multipare cable(oil and gas field), why this communication wire not used in single pair cable?
what is the importance of CV in the control valves? how it is calculated?
what is output of FOUNDATION FIELD BUS transmitter
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
few questions on RS 232,1 question on relationship of impedance and turns ratio, many questions on flowmeters
what is cems analyzer explain with principle and drawing ?
1. For Steam drum level signal, why do we compensate with drum pressure signal? 2.For main steam Flow signal is comensated with main steam temperature signal and main steam pressure signal why?