Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / kj
Most installations are have a PF between 0.8 and Unity
lagging. By rating the DG to 0.8 PF it can operate in most
situations without problems.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is the effect on in Zone and out zone fault if Phase side CT is Vk/2<30 mA and Neutral side is CT is Vk/4<30 mA for Transformer REF protection
Different STANDARDS (BS, IS, IEC etc) gives different informations on CT specification. How they correspons w r t each other (i.e I mean to say BS provides "knee point voltage" but IS does not, then how can i select CT)
what is positive , negative & zero equivalent system resistance
why asa method ZPF method is more accurate than ASA method?
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
What it the purpose of parallel phasing transfomers??
Why increase in current leads to increase in conductor temperature?
What is power factor why we should maintain the power factor unless what will happen
can we do the star delta connection of capacitor for 3- phase motor starter.
What is meant by Low Resistance Cable and High Resistance Cable.
why impedance relay is used for medium transmission line protection
What does bode plots shows?
how we calculate the withstansing current capacity of wires&cables?
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
Meaning of ingrace protection for motor.for ex IPXY
