My ups output shows 230 v between phase and neutral,but show
zero between phase and earth.Is the system/installation is
correct.If not what will be the possible reasons
- 4 Answers
- 4484 Views
- I also Faced
- E-Mail Answers
Answer Posted / kj
There is no connection between the earth and neutral. This
can be because there is and isolated earth system or
someone did not connect it correctly.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is 100% protection of generator? Why 100% is not used but 95% is generally used?
ELECTRICAL DRIVES: can a motor load system with passive load torque can have equilibrium speed in second quadrant
What is the basic principal, by which DC voltage level is increased more than the supplied AC voltage during conversion. As upto AC level it is contorrled by firing anlge but after maximum level how is it possible.Please clear picture. OR we have to supply the higher level AC?
what about GD square and its important for motor design?
where is the need for short circuit test for 3 see is required and why? can you explain in brief with application
what is the relation between reactive power and power factor for the what is the limit of reactive power and power factor
Why reactors use before incoming of ac vvfd drive?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
Define what is difference between fuse and breaker?
how can we make cable shedule for controll wiring ? which details must be required for it.?
give me a clear defination of inductance,and how can u calculate inductance of a motor
formula for calculation of switchgears(i.e. contactor, fuse, cb, relay etc.), if load current is given?
Why we use duplex coil and hook switch in telephone system?
What is the formula to calculate distribution transformer De-rating on iron losses basis
"TRANSFORMER MODELING AND ANALYSIS" MEANS WHAT AND WHICH TOPICS U READ IN THIS
