an electric bulb or lamp can operate on ac and dc, if yes
then why
Answer Posted / brdganesh
S it can work in dc also by adding shunt resister to
the choke
Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
in battery charging room we find two fuses (one in positive other in negative cables ).why it is so?one fuse is ore than sufficient?
how to generator maintenance (A Check, B check,Etc)
what kelvin's law ?
Is there a possibility to use such a treshold voltage for the NMOS part of a CMOS circuit that during the switching it will start conducting only after the PMOS part will be already closed, by this eliminating the leakedge current? Please note, I'm not asking about the well bias in standby mode, but about the "antileakedge" measures during normal operation.
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
why we use Test Terminal Block in 11 KV and 33 KV electrical panels.
What shall be the secondary output voltage if the primary winding of a 220/6V, 50 Hz transformer is energized by an 110V, 60 Hz supply?
7- What is the Dissipation Factor and the difference between it and Insulation Resistance Test? 8- What is the task (function) of DC and AC reactors in power plant? 9- What is the task (function) of (open delta with earthed) in some types in transformers? 10- What is the base of the selection of the vector group in transformers? 11- What is the zig-zag transformer and its function by drawing in large detail? 12- What is the polarity ? 13- Why we make short between phase(R) in high side and phase (r) in low side in vector group test? Where High Side ( R ,S and T ) and Low Side ( r ,s and t ). 14- What are the time on delay and time off delay? 15- What is the vector group? 15- What is the task (function) of different types of vector group such as Dyn11 , Dd0 , YNd1,……..,?
State the points to be considered for selecting a particular type wiring.
upto how many load can v connect to stabilizer which is used for tv
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
Why L.T.Cable voltage rating is 1.1kV,where as system voltage is 0.415kV?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
How to measure the earth resistance value in a concrete pavement(flood light area)?
how to get electrical supervisor competency certificate in gujarat. i did 3 year diploma in electrical