Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following connection is best suited for 3-ph, 4
wire system
A delta-delta B star-star
C delta-star D star-delta
- 2 Answers
- 9938 Views
- I also Faced
- E-Mail Answers
Answer Posted / sunil
(C)In a distribution system, delta-star is best suited
| Is This Answer Correct ? | 20 Yes | 3 No |
Post New Answer View All Answers
HELLO EVERYONE, I RECENTLY HAVE FOUND ONE PROBLEM, I WAS TAKING NO LOAD TRIAL OF AN HT MOTOR 920 MOTOR , 1440 RPM , 6.6 KV, WITH AUTO TRANSFORMER. AT 450 V, LOAD WAS 40 AMP AND SPEED WAS 250 RPM. BUT AS WE INCREASE VOLTAGE FROM 450 TO 480V, LOAD BECOME 41 AND SPEED REDUCED TO SOME RPM . SO WHICH PHENOMENON ACTED HERE FOR REDUCING SPEED.?? AND IS IT HAPPENING ALWAYS OR IT IS RARE? I ALSO HAVE FACED SUCH PROBLEM WITH FEW LT MOTOR ALSO.
why only exciting current is shown not primary current in transformer???
What is the difference between Delta & Wye windings?
33kv Rated output avilable in market (any where in india)
what is the meaning of the symbol << >> put in transformer drawing
As you achieve greater success with the company after some years, Will you like to be a share holder in our company?
how to calculate the surge level of surge suppressors related to the SF6 cicuit breakers?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
what is the ATS .And how it works.
Is it possible to protect 3phase overload and earth fault of the 3phase system using two CT's.
what causes contact chatter when there is no demand on the air conditioning unit?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
What is the mechanism of WTI
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
