Interested to Buy Any Domain ? << Click Here >> for more details...
How much flow is passing through 6 inch line? There are no gauge, no any transmitters in line.
- 3 Answers
- 6263 Views
- I also Faced
- E-Mail Answers
Answer Posted / kapil sharma
it will depends on the parameters (like RPM and per hour discharge flow capacity) of pump through which this 6 inch line is connected
| Is This Answer Correct ? | 7 Yes | 1 No |
Post New Answer View All Answers
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
What pressure results for a flow transmitter of range 0- 180t/h in the dcs and 0-301mbar in the field using square root extraction. Kindly also suggest formulae for the percentages 0,25,50,75,100?
is motorized valve closed when power shutoff?
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
Any body have know try work calculation ???
protection relay watchdog contact operation?
can anyone can let me know in Eurotron Micro cal 2+ calibrator in milli amps source mode we are not able to get 20 milli amps output it only produces 1.52 milli amps out, but display shows increase in milli amps , and err6 displays, let me know how to remove the err 6.
How to Calibrate Vortex Flow transmitter in field
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
How many ohms are required for proper earthing?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
how to calibrate electro pneumatic positioner 8013 mil controls ltd ?gsr
how to calibrate Necleuonic level transmitter.?
what effects a surging can produce in the compressor
what is the calibration procedure for magnetic flow meter @ onsite
