Interested to Buy Any Domain ? << Click Here >> for more details...
my question is that....few days ago i had installed a three
phase motor starter for an electric saw.the motor will run
and make the hydraulic pressure which will be goes to
pressure cylender by up and down lever.two number of
limitswitches are also installed on cylinder for safety of
motor.now when the arm of cylinder reaches to the upper or
lower limit it will cut the motor's line.and motor will be
stop.now wana know that what will i do that motor runs
continue after the limitswitch cut it down but it shold not
be made any pressure.pls answer me in brief.
- 3 Answers
- 4637 Views
- I also Faced
- E-Mail Answers
Answer Posted / malik mazhar
c0ntr0l its up and d0wn s0len0id valve thr0ugh limit switc..
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What happen to the transformer if the OLTC frequently used for lower and raise occured 50times daily?
my b-tech percentage is 50%. what answer will satisfy the hr ?
Define step response?
why actual valve timing diagram is different than ideal valve timing digram of a 4 stroke engine?
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
Define bibo stability.
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
what are the different sizes of U.G. cable & where these cabl;es are used according to voltage ..
how to find the resistance and gap volatage of the diode??
Give idea about General Engineering. From which book i can study this topic. Pl. reply me via email. My email is ravi@bhelhwr.co.in, also give the name of book/website, from where i can prepare it.
What does Bode plot tell you?
how to set relay setting? and example calculation...
if the armature current in a dc generator is ac ( sinusoidal ) why doesnt the sjhape af armature mmf a sinusoidal (ni) ? armature mmf in case of a dc machine is triangular.
Any one who apply for Ferro Scrap Nigam Limited cn join with me at rajuhalder@indiatimes.com or 09669717028
tell me some type of questions throught which i can prepare for exam and do my best
